5: Commands and Levels
EDS-MD Command Reference 305
Sets the threshold in bytes. After this many bytes are received,
they are
forwarded without delay.
Enters the tunnel level.
<line> = number of the tunnel line (serial port) to be confi-
gured.
Stores the current configuration in permanent memory.
Sets the xoff character for use with software flow control on
this line.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Sets the xon character for use with software flow control on
this line.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
link (config-ethernet:eth0) level commands
Restores the default duplex setting, which is auto.
Restores the default speed setting, which is auto-negotiate.
Sets duplex mode to auto.
Sets duplex mode to full.
Sets duplex mode to half.
Exit back to interface configuration level
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Sets the speed of the Ethernet link to 10 Mbps.
Sets the speed of the Ethernet link to 100 Mbps.
Sets the speed of the Ethernet link to auto-negotiate.
Stores the current configuration in permanent memory.
log (config-diagnostics-log) level commands
Restores the factory default maximum Log file size.
Restores the default log output, which is disable.
Exits to the next higher level.
Sets the maximum size in Kbytes for the Log file.
Enables log to filesystem.
Enables log to serial line.
Shows the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Stores the current configuration in permanent memory.
modem (tunnel-modem:8) level commands
