5: Commands and Levels
EDS-MD Command Reference 310
Displays tunnel modem status.
Does not send Modem Response Codes.
Sends Modem Response Codes out on the Serial Line.
Stores the current configuration in permanent memory.
modem (tunnel-modem:2) level commands
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
The incoming RING is followed by the IP address of the caller.
Does not echo modem commands.
Does not echo the +++ characters when entering modem
command mode.
Echoes the +++ characters when entering modem command
mode.
error unknown commands disable
Returns OK on unknown AT commands.
error unknown commands enable
Returns an error upon unknown AT commands.
Returns to the tunnel level.
incoming connection automatic
Automatically answer incoming network connections.
incoming connection disabled
Disable incoming network connections.
incoming connection manual
Wait for an ATA command before answering an incoming net-
work connection.
Removes optional CONNECT string information for modem
emulation.
Asserts tunnel modem status with current configured values.
Uses numeric type responses.
Uses text type responses.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Displays tunnel modem status.
Does not send Modem Response Codes.
Sends Modem Response Codes out on the Serial Line.
Stores the current configuration in permanent memory.
modem (tunnel-modem:1) level commands
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
The incoming RING is followed by the IP address of the caller.
Does not echo modem commands.
