Setup
PagePrinter Network Adapter: Utilities & Environments 2-5
TCP/IP
networks
Step 3: set the IP address, netmask, and gateway
You can set the IP address, netmask, and gateway for this adapter in several
ways.
The simplest way to set the information is directly on the printer’s control
panel. For information about setting the information on the printer’s control
panel, go to “Setting the information via the printer control panel” on page 2-8.
You may:
• Use a TCP/IP bootstrap protocol (BOOTP), if you have a BOOTP server
running on your network. For help, go to “Setting the information using a
bootstrap protocol” on page 2-6.
• If you are installing the adapter on a complex network and are also setting up
NetWare, run the Network Printer Utility in that environment. You can set the
address, netmask, and gateway from that environment.
You may also:
• Set the address using a Remote Address Resolution Protocol (RARP) server
running on your network. For help, go to “Setting the information using a
RARP server and telnet” on page 2-10.
• Set the address by editing the Address Resolution Protocol (ARP) table on
one of your host computers
that is on the same local area network as the
adapter.
For help, go to “Setting the information by editing an ARP table and
using telnet” on page 2-11.
If the above methods won’t work for your network, contact your point of
purchase.
