User's manual NAVIGON 5100 | 5110
Navigation - 21 -
5.1.1 Initialising the GPS-receiver
Note: It can take up to 20 minutes to initialise the integrated GPS
receiver for the first time.
Each time you switch on the receiver after this, the GPS reception will
start within one minute.
If the navigation device has been switched off for more than a week, the
next initialisation can take up to 10 minutes.
As soon as the navigation device has been switched on, initialisation of
the GPS-receiver will begin.
In the right-hand top corner of the display, you will see the GPS
symbol.
As soon as data from at least 3 satellites is received, the symbol
changes to
GPS Ready.
Note: If the GPS symbol displays GPS Ready after considerably less
than 20 minutes, it is advisable to leave the receiver switched on for at
least a further 15 minutes so as to ensure reliable operation.
Caution! If you have connected the navigation device to the power
supply via the vehicle's cigarette lighter, remove the connector before
you leave the vehicle standing for a longer period of time.
As the GPS receiver requires a constant supply of power, it could drain
the vehicle´s battery.
Opening the Main Window
The MAIN WINDOW opens when the navigation software starts.
If another window is open, tap the
(Back) button. The previous
window will open.
Tap the
(Back) button repeatedly, until the MAIN WINDOW opens.
5.2 Specifying a new destination
New destinations for the NAVIGON 5100 | 5110 are all destinations that
you have not yet navigated, or you have not yet stored.
You can enter an address here, select a special destination, or select a
destination from the quick search function.
When you enter a new destination for the first time, the C
OVERED
COUNTRIES
list opens.
Tap on the country in which your destination lies.
