35
Checking, canceling, or correcting the Timer Programming
information
1
Press [TIMER SET].
disappears from the front display.
2
Press [VCR Plus+ TIMER]
twice.
Timer Programming
2. ---
3. ---
1. JAN/01 12:57AM 1:57AM 8 DVD HQ
Date Start End CH Mode
DVD
VCR
VCR DVD
Timer Programming list will
appear.
3
Check the information on the list you will need.
4
To clear the Timer Programming:
Using [K / L], select your desired program.
Press [CLEAR].
To correct the Timer Programming:
Using [K / L], select your desired program.
Press [OK].
Next, correct the Timer Programming by using
[K / L / { / B].
Finally, press [OK] again.
5
Press [VCR Plus+ TIMER] to exit.
6
Press [TIMER SET] to return to the timer standby mode.
To stop the Timer Recording in process
Press [STOP C] to stop the disc recording or [STOP C / EJECT A]
to stop the videotape recording on the front panel of the main unit.
[STOP C] on the remote control is not effective.
If the timer program did not complete correctly, the error
number appears in the Timer Programming list.
• A program with the error number is grayed and asterisked in the Timer Programming list.
• Once the Timer Programming list with error line(s) is displayed, or after canceling and setting again the timer standby
mode, the program line(s) with error will be cleared.
Timer Recording (cont’d)
Helpful Hints
• Press [VCR Plus+ TIMER] to
check the Timer Programming in
process.
- When the Timer Recording is in
progress, that program will be
highlighted in red.
- While using the side of the unit
that is free from Timer Recording
(either DVD or VCR) during timer
standby mode, no programs will be
highlighted even if you press [VCR
Plus+ TIMER] to confirm the
program information. In this case,
you cannot select other program
either for correction or add any
new programs.
• The unit will be turned on
automatically before the recording
time.
SETUPDISC MENU
DISPLAY
BACK
OK
REW FFW
PLAY
PREV PAUSE NEXT
COMMERCIAL
SKIP
CH
TV
VOL
CLEAR REC MODE
.@/: DEFABC
GHI MNOJKL
PQRS WXYZTUV
VCR Plus
+
TIMER
TIMER
SET
VCR REC DVD REC
DIRECT
DUBBING
STOP
1,62,5
4
• E23, E27, E28, E31, E32, E33 and E34 are not displayed.
E1-22
E37-39
Recording error other than
below
E41 Power failed
E42 No disc when recording
E24 Unrecordable disc
E25-26 Copy prohibited program
E29 Disc protected E43 Already 49 titles recorded
E30 Disc full
E44 Already 254 chapters
recorded
E35 PCA full
E45 Copy prohibited program
E46 It is impossible to record
additionally on a disc
recorded by other units when
setting Replace Disc Menu
to OFF.
E36 Already finalized Video format
disc
E40 Some portion has not been
recorded because of program
overlapping. Recording did not
start at the start time.
Press [CLEAR] to erase the
selected program.
Timer Programming
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
JAN/01 12:57AM 1:57AM 8 DVD E22
Date Start End CH Mode
DVD
VCR
VCR DVD
*
Each error number means:
E9A90UD_EN.indb 35E9A90UD_EN.indb 35 6/12/2006 4:21:33 PM6/12/2006 4:21:33 PM
