30
INTERRUPTING A COPY RUN
(Interrupt copying)
A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,
the copy run will resume using the original copy settings.
1
Press the [INTERRUPT] key to
interrupt the copy run.
The INTERRUPT
indicator will light up and
the display will show "0".
The INTERRUPT
indicator will blink until
the page that was being
copied when the
[INTERRUPT] key was
pressed is finished.
2
Remove the previous original(s) and
place the original(s) of the interrupt
copy job.
3
Press the [START] key ( ).
The copy will be
delivered to the output
tray slightly offset from
the copies of the
interrupted run. (Shifter
function)
The Shifter function can
be disabled in the user
programs. (p.00)
A: Copies made before the interrupt copy job
B: Interrupt copy job
C: Copies made after the interrupt copy job
4
When the copy job is finished, press
the [INTERRUPT] key and remove the
original(s).
The INTERRUPT indicator will go off, indicating
that the interrupt function is no longer operating.
The copy settings will automatically revert to the
settings selected for the copy run before the run
was interrupted.
5
Replace the previous original(s) and
press the [START] key ( ).
The interrupted copy run will resume.
Interrupt copying is not possible when the user programs are being configured, or when automatic two-sided
copying, sort/group copying, or 2 IN 1 / 4 IN 1 copying is being performed.
Note
• If the SPF/RSPF is being used, the copy
run will not stop until the set number of
copies is completed.
• If auditing mode is enabled:
"- - -" will appear in the number of copies
display. Enter your 3-digit account number.
Copying will not be possible unless a
correct account number is entered. (p.00)
Note
B
C
A
