24
Chapter 2 Installation
About SCSI parity
When the SCSI parity function is enabled, parity checks are performed on all
data passing through the SCSI bus. The factory default settings for SCSI parity
are as follows:
• Library: Enabled (YES)
• AIT Drive: Enabled (YES)
Caution
Do not duplicate SCSI IDs.
Note
The SCSI IDs can also be set through a browser.
1
At the status display, press the [MENU] button for two seconds.
2
Use the V and v buttons to select “4.SCSI”, then press the [ENTER]
button.
3
Set the SCSI ID and SCSI parity of
the library.
1 When the “ID” of “Library” setting flashes, use the V and v buttons to
set the SCSI ID, then press the [ENTER] button.
2 When the “Parity” setting flashes, use the V and v buttons to set the SCSI
parity, then press the [ENTER] button.
Select “YES” to enable the SCSI parity function.
4
In the same manner, set the AIT Drive.
5
When “[ENTER] to activate”
appears, press the [ENTER] button.
6
When “[Enter] to reset” appears,
press the [ENTER] button.
The system reboots.
Caution
If you change the SCSI ID while the library is connected to the host
computer, you must also restart the host computer.
ID Parity
Library 01 YES
Drive 02 NO
ID Parity
Library 01 YES
Drive 02 NO
[ENTER] to activate
Warning 12:34
Reboot the system to
activate the setting
[ENTER] to reset
