54
Chapter 4 Operating the AIT Library
To replace a cartridge set in the AIT library:
1
At the status display, press the [MENU] button for two seconds.
2
Use the V and v buttons to select “2.Eject/Insert”, then press the [ENTER]
button.
“Eject/Insert” appears.
3
Select “1.Eject From Library”, then
press the [ENTER] button.
4
Select the cartridge ejection
method, then press the [ENTER]
button.
• When you want to specify one
slot and eject its cartridge, select
“1. Single Mode”.
• When you want to eject several
cartridges consecutively, select
“2. Multiple Mode”. In this case,
you only need to specify the first slot.
5
Use the V and v buttons to set the
element address of the slot where
the cartridge to replace is set, then
press the [ENTER] button.
6
When “[ENTER] to activate”
appears, press the [ENTER] button.
The cartridge dock shutter opens.
7
Remove the cartridge from the slot.
Eject/Insert 12:34
1.Eject From Library
2.Eject From Drive
3.Insert Into Library
Eject 12:34
1.Single Mode
2.Multiple Mode
Slot 01
Slot 01
[ENTER] to activate
