A SERVICE OF

logo

Open as PDF
next previous
75
PRELIMINARY
3 Communication (continued)
3.1 Setting EEPROM on the NH-M Board (continued)
3.1.2 Calibrating EEPROM Gain
WARNING: This procedure must be performed in bypass mode (see section 1.6).
b) Select the parameter you want to calibrate and click its gain icon
c) Key in the actual value to the “Actual Measured:” column of the dialogue box
d) Key in the LCD value to the “UPS Detected:” column of the dialogue box
e) Click the “Calculate” icon (the New Gain Value will auto-calculate)
f) Click the “OK” icon (the dialogue box will close)
g) After calibrating the gain, click “Update All” and wait for the procedure to complete itself
Instructions for calibrating the EEPROM gain of the UPS parameters are as follows:
(For polling procedure, please refer to section 3.1.1)
a) Click the “Gain” tab (Figure 3.1.2a)
Fig 3.1.2a