A SERVICE OF

logo

VX-800 OPERATING MANUAL
4
is selected by the channe selector knob.
For further details, contact your
dealer..
r Rotate the VOL/
PWR knob to set the
volume level. If no
signal is present, press
and hold in the Moni-
tor button (the center
button on the left side)
more than 2 seconds;
background noise will
now be heard, and
you may use this to set
the VOL/PWR knob
for the desired audio
level.
Press and hold the Monitor button more than 2 sec-
onds (or press the Monitor button twice) to quiet
the noise and resume normal (quiet) monitoring.
OPERATION
r To transmit, press
and hold the PTT
switch. Speak into
the microphone area
of the front panel
grille (lower right-
hand corner) in a nor-
mal voice level. To return to the Receive mode,
release the PTT switch.
r Press the Soft key (if assigned to the Scan func-
tion) or switch the Toggle Switch to the assigned
“Scan” position (when so programmed by your
dealer) to start the scanner. The scanner rapidly
steps through each of the dealer-programmed
channels, looking for incoming calls.