Starting your dishwasher
Six program pads, a hidden LOCK-OUT pad and
the electronic display allow you to program and
monitor the dishwasher’s operation. A program-
ming tone sounds each time a pad is touched un-
der normal operation.
When first installed, “PF” will show on the display.
Press CANCEL pad twice to clear the display. To
startthe dishwasher, press the PROGRAM pad. The
dishwasher is pre-programmed for the NORMAL
program with the AIR DRY option. If you want this
program, touch START.
To select a different program and/or option, just
touch the PROGRAM and/or OPTION pad until the
program and/or option you desire appears in the
display. Each touch of the pad advances the dis-
play to the next program or option. After each use,
the dishwasher remembers the program and op-
tions used. Ex: The next time the display is lit up
for programming, it will show the last cycle that
was run.
Selecting a program
When dishes are loaded and ready to be
washed...
1. Spin the Upper Spray Arm to make sure nothing
will stop it from turning.
2. Close and latch the door.
3. Run hot water at the sink nearest the dishwasher
until it is hot.
4. Select a desired program by touching the
PROGRAM pad.
5. Select an Option by touching the OPTIONS pad.
6. Touch START pad.
POTS & PANS
Maximum cleaning for cooked-on
or baked-on foods. The program
time delays while the dishwasher
automatically heats the water to
145°F (63°C) in both washes and the
last rinse (marked
l
).
Program time’*
is 77 minutes plus the time needed to ’
heat the water.
WASHING AND RINSING AND
HEAT WATER HEAT WATER
DRYING CLEAN
HEAVY
WASHING
RINSING
DRYING CLEAN
A double wash for heavily soiled
loads.
Program time**
is 73 minutes.
NORMAL
WASHING
RINSING DRYING CLEAN
For normal, evervdav soiled loads.
/-- /-,
(The Energy Guide Label data is
’
based on this program.)
Program
time**
is 72 minutes.
**Program time includes heated dry times. 30 minutes less time is required with AIR DRY selected.
8
