Replacing
,
2. Line up opening in the reflector
bowl with the surface unit
receptacle.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle.
4. Push the surface unit terminal intc
the receptacle. When the terminc
is pushed into the receptacle as
far as it will go, the surface unit wi
fit into the reflector bowl.
CAUTION: Reflector bowls reflect heat back to the utensils on the
surface units. They also help catch spills. When they are kept clean,
they reflect heat better and look new longer.
If a reflector bowl gets dlscolored, some of the utensils may not be
flat enough, or some may be too large for the surface unit. In either
case, some of the heat that’s meant to go int6 or around a utensil
goes down and heats the reflector bowl. This extra heat can discolor
it. See “Cooking Guide” for further information.
I!
