6. After cleaning the gas tube opening
and ports, replace the burner cap and
burner grate. To replace burner cap,
make sure cap is properly aligned and
leveled. Fit locating pegs into the
recess in the underside of the cap. The
cap must be correctly seated on the
burner body for proper operation of the
burner.
7. Turn on the burner to determine if it will
light. If the burner does not light after
cleaning, contact an authorized
Whirlpool service technician. Do not
service the sealed burner yourself.
Locating pegs
Removing the oven door
Removing the oven door will help make it
easier to clean the oven,
Electrical Shock Hazard
Make sure all controls are OFF and the
oven is cool before removing oven
door.
Failure to do so could result in burns or
electrical shock.
To remove:
1.
Open the door to the first stop position.
2. Hold the door at both sides and lift it at
the same angle it is in.
3. To replace, fit the bottom corners of the
door over the ends of the hinges. Push
the door down evenly. The door will close
only when it is on the hinges correctly.
19
