PROBLEM
Burner flames
lift off ports,
are yellow, or
are noisy when
turned off
Burner makes
popping noise
when on
Control knob(s)
will not turn
Cooking results
are not what
you expected
The display
is showing
“88:88”
POSSIBLE CAUSE
Air/gas mixture is incorrect.
Burner is wet from washing.
You are not pushing in before
turning.
The range is not level.
The oven temperature seems
too low or too high.
The oven was not preheated
as the recipe calls for.
The recipe has never been
tested or is not from a reliable
source.
The pans are not the type or
size recommended in the
recipe.
There is not proper air circu-
lation around pan when
baking.
Flame size does not fit the
cooking utensil being used.
When broiling, you have not
completely closed the broiler
drawer.
There has been a power
failure.
.--
SOLUTION
Contact an authorized Whirlpool
service technician to check air/gas
mixture.
Let dry.
Push control knob(s) in before turning
to a setting.
Level range. (See Installation
Instructions.)
Adjust the oven temperature control.
(See “Adjusting the oven temperature
control” on page 13.)
Preheat oven if called for in recipe.
Use only tested recipes from a reliable
source.
Refer to a reliable cookbook for recom-
mended pan type and size.
Allow 1 M to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Adjust flame size to fit cooking utensil.
Completely close broiler drawer.
Reset the clock. (See page 10.)
25
