A SERVICE OF

logo

IES-5000 Series User’s Guide
32 Chapter 3 Hardware Installation and Connections
Figure 9 Tightening Card Thumbscrews
3.3.2 Removing MSC and Line Cards
1 Disconnect all cables from the card.
2 Loosen the two thumbscrews.
3 Pull the two ejector levers firmly until the front of the card is clear of the chassis. Pull the
ejector levers until they are perpendicular to the front panel.
4 Grasp the center of the front panel of the card with one hand and place the other hand
under the card to support it.
5 Slide the card out of the slot.