Configuring Dial Security Remotely
10-9
3
If Dialback is enabled at the host Business Modem’s site, set your modem
to answer the host Business Modem when it dials back.
4
Call the host.
5
After the call ends you can disable Auto Answer.
Configuring Dial
Security Remotely
The host administrator can configure the host’s security settings remotely.
At the host device, you must have previously enabled remote access and
assigned a remote-access password that allows view-and-change
privileges (see Chapter 10, Accessing and Configuring the Business
Modem Remotely). You may want to use your administrative password as
your remote-access password.
Dialing In From the Remote Site
1
From the remote site, connect to the host using Dial Security. Once a
connection is made, follow the instructions for beginning a
remote-access session as described in Chapter 10,
Accessing and
Configuring the Business Modem Remotely
.
2
When remote access has been granted, use the AT%S= command to
access the Dial Security accounts. See
Maintaining Security Accounts
section earlier in this chapter.
To view the security account information use
ATI10
.
3
Make any configuration changes and execute them immediately by
entering
AT%C2
.
4
To end the remote session and reactivate Dial Security on the host, reset
the host device by issuing
ATZ
.
For your modem to be set Command
To answer the Dialback call
ATS0=1
For your modem to Command
Disable Auto Answer
ATS0=0
