A SERVICE OF

logo

Wiring
AT-8762D
lmpact Tool
Tool
Spudger
110 Impact Tool
788J1
788 K1 Retainer
Modular Plug Pressers
Figure 4-3. RJ21X Wiring Field Tools
To connect the RJ21 X network interface to the control unit, follow the steps
below. Figure 4–3 shows the tools you need.
1 For each piece of hardware, drill two diagonally opposite holes into the
backboard, allowing for a 1/16-inch (1.6 mm) space between each piece
of hardware.
2 Mount the wire troughs and the termination blocks.
There is a wire trough above and below each termination block.
Connecting the Control Unit to the Network Interface 4-7