3-12 Using the Control Panel for Printers
Configuring Apple EtherTalk Phase
Parameters (Ethernet Cards Only)
You can configure Apple EtherTalk parameters if the Apple
EtherTalk protocol is enabled (
ETALK=ON*
), and the PostScript
printer language is enabled.
To ensure the PostScript printer language is enabled, check the
Configuration Menu
(for 5Si Series printers) or the
JOB MENU
(for other printers).
PERSONALTY=PS*
or
PERSONALTY=AUTO*
should be set.
To configure EtherTalk parameters
NOTE
For HP 2500C/CM Professional Series
and DesignJet ColorPro GA printers, see the
“HP 2500C/CM Professional Series and DesignJet
ColorPro GA Control Panel” instructions at the
end of this chapter.
If you haven’t already done so, enable EtherTalk by following the
instructions described in “To enable or disable network protocols”
in this chapter.
1. Take the printer offline by pressing
[On Line]
or
[Go]
to indicate
offline.
2. Press
[Menu]
repeatedly until the following message is displayed
on the control panel:
3. Press
[Item]
until
CFG NETWORK=NO*
appears.
4 Series printers
AUX IO MENU
4 Plus and 4V Series printers
MIO MENU
Color LaserJet printers
(
Proceed to Step 4
)
MIO CONFIG MENU
CFG NETWORK=NO *
4Si Series printers (select the
card slot being configured)
MIO MENU 1
or
MIO MENU 2
5Si Series printers (select the
card slot being configured)
HP MIO 1 MENU
or
HP MIO 2 MENU
5 Series printers
HP MIO MENU
