A SERVICE OF

logo

Open as PDF
next previous
Appendix C Printer Memory and Expansion 317
Adjusting Memory Settings
3. Using a software application, download all the fonts you want to use in the selected
language.
4. Print a configuration page (page 228
). The amount of memory used by the fonts is
listed next to the language. Round this figure up to the nearest 100 KB. (For
example, if 475 KB are shown, 500 KB should be reserved.)
5. From the Configuration Menu, set PCL MEMORY or PS MEMORY to the value determined
in step 4.
6. Repeat step 3. (You must download all fonts again. See the note below.)
Note When you change the Resource Saving setting, all downloaded resources
(such as fonts or macros) will need to be downloaded again, unless they
are stored on an optional hard disk or flash DIMM.