Software Fixes Release Notes for 07.8.04
34
50592 Multicast jumbo packets are not supported on the
10 Gigabit Ethernet module.
Multicast all 07.8.01c
51482 The system reloads when you enter the ip tftp
source loopback 19899960 command in config
mode. This is because the Valid Port Range value is
not checked.
CLI 07.8.00 07.8.01c
07.8.01d
34400 sFlow does not detect an IP router ID or any
physical address other than the default value. If
sFlow is running when you modify the address, the
new agent address is displayed in show sflow
command output displays, but is not displayed in a
trace. (The trace displays the default address.)
sFlow 07.8.00 07.8.01d
44260 Accessing HTTP may cause the system to reload at
“ProcessCookie”.
HTTP 07.8.01 07.8.01d
45319 When you enter the ip rebind-acl all command, the
following error message is displayed:
Exceed max DMA 9 L4 cam resource,
using flow based ACL instead.
ACL 07.6.06 07.8.01d
47254 On a tagged port, an incorrect ACL value is applied
to filter packets
ACL 07.8.00 07.8.01d
51175 A route fails to boot up properly when you configure
sFlow globally by entering the sflow enable
command and disable remote access to
management functions by entering the
management-ip-disable command on a VE
interface.
sFlow 07.8.00 07.8.01d
51482 The system crashes at “ip_get_port_ip_address”
after you enter the ip tftp source loopback
19899960 command because the valid port range
value is not checked.
CLI 07.8.00 07.8.01d
52419 SSH disconnects the SSH client after the
configured idle time expires even during active CLI
activity in an SSH session.
SSH 07.8.00 07.8.01d
52659 An IGMP query (for example, to 224.0.0.1) is sent
on a blocking port. This happens only with different
IGMP versions or when one port in the VLAN is a
non-querier.
IGMP 07.8.01 07.8.01d
53881 SNMP OID “snAgentConfigModule” type displays
the incorrect type for certain modules.
SNMP 07.8.00 07.8.01d
54208 The configuration of a TFTP or Telnet source
interface is not supported.
CLI 07.8.01 07.8.01d
54250 The debug span all_802_1D_events vlan <vlan-
id> command is not supported even though it is
listed as a valid command option.
802.1d, CLI 07.8.00 07.8.01d
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
