41
Release Notes for 07.8.04 Software Fixes
57758 On a network with OSPF Equal-Cost Multi-Path
(ECMP) enabled, only the two next hops can be
viewed when four next-hops exist.
OSPF 07.8.02
57806 When you enter the no port security command, all
interface-level configurations are removed.
Port Security 07.8.02
57847 On an EP 24 Port 100Base-FX module (J8178A),
when an outbound ACL is applied to a virtual
routing interface, the ACL does not block traffic from
interfaces on the same module.
ACL 07.8.02
58095 After you enter the show version command, the
following error message is displayed to indicate an
incorrect device ID for E2PROM:
Read from device id 6 failed.
Starting in release 07.8.02, the valid device ID is
checked before it is accessed.
ACL 07.8.02
58101 Secure MAC addresses configured for a port are
displayed in show mac command output, even
though port security was disabled on the port.
Port Security 07.8.02
58397 When rate-limiting is configured, the correct value
for port utilization is not displayed in show stat
command output.
SNMP 07.8.02
58420 Data exception messages are displayed when you
click the logout button on the Web management
interface on a device that has the allow-no-
password setting configured for web management.
Web
Management
07.8.02
58428 On a 2-Port 10 Gigabit Ethernet module, a memory
leak occurs on a 2-port trunk when the trunk is
configured and then unconfigured.
Trunking 07.8.02
58567 On an EP 8 Port Mini-GBIC Redundant
Management module, when you configure port
security on a tagged port, MAC addresses are
learned on an incorrect VLAN.
Port Security 07.8.02
58718 On a 1-Port 10 Gigabit Ethernet module, the HP
Discovery Protocol (FDP) cannot transmit traffic on
an outbound 10 Gigabit tagged port.
FDP 07.8.02
58732 When a routing switch forwards a packet via the
CPU, the port mask may be sometimes accessed
incorrectly, resulting in a system reload.
IP Stack 07.8.02
58831 A packet is not flooded in a port VLAN when its
destination IP address does not match any of the
configured IP subnet VLANs.
VLAN 07.8.02
58852 Earlier software images stored BGP community
attributes that can be up to 256 bytes long. Starting
in release 07.8.02, BGP community attributes with
lengths up to 4096 bytes are supported.
BGP 07.8.02
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
