A SERVICE OF

logo

5. Remove the retainer bracket from the failing drive and install it on the new
optical drive.
6. Slide the new optical drive into the drive bay until it snaps into position.
7. Connect the signal and power cables to the drive.
8. To reinstall the front bezel, align the plastic tabs on the bottom of the bezel
with the corresponding holes in the chassis, then pivot the bezel inward until it
snaps into position.
9. Go to “Completing the FRU replacement” on page 106.
Figure 27. Retainer bracket for optical drive
Figure 28. Replacing the optical drive
104 Hardware Maintenance Manual