Use To
Sharpness
1–5
Adjust the amount of sharpness on a scanned image.
Note: 3 is the factory default setting.
Temperature
‑4 to 4
Enable the user to specify “warm” or “coo”l outputs. “Cool” values generate a bluer
output than the default while “warm” values generate a redder output than the
default.
Print Settings
Copies
1–999
Specify a default number of copies for each print job.
Note: 1 is the factory default setting.
Paper Source
Tray [x]
Multipurpose Feeder
Manual Paper
Manual Envelope
Set a default paper source for all print jobs.
Note: Tray 1 is the factory default setting.
Collate
1,1,1 ‑ 2,2,2
1,2,3 ‑ 1,2,3
Stack the pages of a print job in sequence when printing multiple copies.
Note: “1,2,3 ‑ 1,2,3” is the factory default setting.
Sides (Duplex)
1 sided
2 sided
Specify whether prints are on one side or on both sides of the page.
Note: “1 sided” is the factory default setting.
Staple
Off
On
Specify whether the printed outputs are stapled.
Notes:
• Off is the factory default setting.
• This menu item appears only when a staple finisher is installed.
Hole Punch
Off
On
Specify whether prints have punched holes.
Notes:
• Off is the factory default setting.
• This menu item appears only when a supported staple, hole punch finisher is installed.
Hole Punch Mode
2 holes
3 holes
4 holes
Specify the number of holes to be made on the prints.
Notes:
• “3 holes” is the U.S. factory default setting. “4 holes” is the international factory default
setting.
• This menu item appears only when a supported staple, hole punch finisher is installed.
Duplex Binding
Long Edge
Short Edge
Define binding for duplexed pages in relation to the page orientation of the printed document.
Notes:
• Long Edge assumes binding along the long edge of the page (left edge for portrait and top
edge for landscape).
• Short Edge assumes binding along the short edge of the page (top edge for portrait and
left edge for landscape).
Understanding the printer menus 215
