3 For Macintosh users, add the scanner:
a From System Preferences in the Apple menu, navigate to the list of scanners, and then select + > IP.
b Type the scanner IP address in the address field.
Note: Obtain the scanner IP address from the TCP/IP section in the Network/Ports menu.
c Apply the changes.
Adding available options in the print driver
For Windows users
1 Open the printers folder, and then select your printer.
2 Open the printer properties, and then add or manually install any options.
3 Apply the changes.
For Macintosh users
1 From System Preferences in the Apple menu, navigate to your printer, and then select Options & Supplies >
Driver.
2 Add any installed hardware options.
3 Apply the changes.
Networking
Notes:
• Purchase a MarkNet
TM
N8350 wireless network adapter first before setting up the printer on a wireless network.
• A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP), Wi-Fi
Protected Access (WPA), and WPA2 are types of security used on a network.
Preparing to set up the scanner on an Ethernet network
Note: If your network automatically assigns IP addresses to computers and other devices, continue on to installing
the scanner.
To configure your scanner to connect to an Ethernet network, organize the following information before you begin:
• A valid, unique IP address for the scanner to use on the network
• The network gateway
• The network mask
• A nickname for the scanner (optional)
Note: A scanner nickname makes it easier for you to identify your scanner on the network. You can choose to
use the default scanner nickname, or you can assign a name that is easier to remember.
You will need an Ethernet cable to connect the scanner to the network and an available port where the scanner can
physically connect to the network. Use a new network cable when possible to avoid potential problems caused by a
damaged cable.
Additional scanner and printer setup 56
