23
<Connection with the DVD Extension Unit
with HDD>
The figure shows the WJ-HDE510 with an HDD.
The DVD-RAM is used for backup of the data recorded
on the WJ-HD500A Digital Disk Recorder as well as for
storing the data of the extension hard disk drive units in
the system.
1. Connect between the COPY port on the WJ-HD500A
and the COPY IN port on the 1st DVD Extension Unit
with the supplied (WJ-HDE510) SCSI cable.
Plug the cable end with magnetic core into the
COPY port, and the other ends into the COPY IN
port.
2. Connect between the EXT STORAGE port on the
WJ-HD500A and the EXT IN port on the 1st DVD
Extension Unit with the supplied (WJ-HDE510) SCSI
cable.
Plug the cable end with magnetic core into the EXT
STORAGE port, and the other ends into the EXT IN
port.
Repeat the connection steps for any subsequent
extension units.
The system can be expanded by up to 6 Extension
Units. To connect the other Extension Units, refer to
the operating instructions of each unit for further
information.
●
Switch Settings
1. Set MODE switch #2 on the rear of the WJ-HD500A to
ON when connecting a DVD Extension Unit with an
optional HDD.
2. Set the SCSI ID for the DVD Extension Unit and each
subsequent Extension Unit with the – or + selector on
the rear of each Unit.
0 to 5: IDs for Extension Units.
Note: SCSI ID 6 and 7 are reserved for the WJ-HD500A
Digital Disk Recorder.
3. Set the termination switches on the rear of the Extension
Units to ON or OFF.
ON: Is applied to the extension unit located at the end
of the SCSI chain.
OFF: Is used for units other than the end unit.
