3. Preparation
19
3.6 Adjusting base unit
volume
Ringer volume
While the unit is idle, press {A} or {B}.
L If any documents are in the document
entrance, you cannot adjust the volume.
Confirm that there are no documents in the
entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display “RINGER
OFF= OK?”.
2. Press {SET}.
L When a call is received, the base unit will not
ring for outside calls and will display
“INCOMING CALL”. The base unit will ring at
the low level for intercom calls.
L To turn the ringer back ON, press {A}.
Ringer type
L You can select the ringer types from one of 6
types for outside calls (feature #17 on page
62).
Handset receiver volume
While using the handset, press {A} or {B}.
Speaker volume
While using the speakerphone, press {A} or
{B}.
Answering machine volume
While listening to messages, press {A} or
{B}.
Initial Programming
3.7 Dialling mode
If you cannot dial (page 24, 40), change this
setting depending on your telephone line
service.
3.7.1 With the cordless handset
1 Press {j/OK}.
2 Select “Base Unit Setup”, then press
{>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page 73).
4 Select “Call Options”, then press {>}.
5 Select “Dial Mode”, then press {>}.
6 Select the desired setting, then press {>}.
– “Tone” (default): For tone dial service.
– “Pulse”: For rotary pulse dial service.
7 Press {ih}.
3.7.2 With the base unit
1 Press {MENU}.
SYSTEM SETUP
PRESS [()]
2 Press {<} or {>} repeatedly to display the
following.
DIALLING MODE
=TONE [±]
{A}{B}
{SET}
{ih}
{j/OK}
{>}
{A}{B}{<}{>}
{MENU}
{SET}
FC962HK-PFQX2283ZA-en.book Page 19 Thursday, September 15, 2005 4:20 PM
