9. Programmable Features
72
Resetting the cordless handset to its
default settings
1. Press {j/OK}.
2. Select “Handset Setup”, then press {>}.
3. Select “Other Options”, then press {>}.
4. Select “Reset Handset”, then press {>}.
5. Enter “0000” (default cordless handset PIN).
L If you changed the PIN, enter it (page 71).
6. Select “Yes”, then press {>}.
7. Press {ih}.
Note:
L The following items will be deleted or reset to
their default settings:
– Settings listed on page 69 (not including
items using the base unit PIN)
– Redial list
– Voice enhancer
– Category names
– Category ring tones
L The following items will be retained:
– Cordless handset phonebook items
(category names and ring tones will be
reset to their default settings.)
– Date and time
9.5.7 Programmable functions
using the base unit PIN
Helpful hints:
L To exit programming, press {ih} at any
time.
9.5.8 Call Options
Changing the recall (flash) time
Change the flash time of the cordless handset, if
necessary, depending on the requirements of
your service provider or PBX.
1. Press {j/OK}.
2. Select “Base Unit Setup”, then press
{>}.
3. Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page 73).
4. Select “Call Options”, then press {>}.
5. Select “Recall”, then press {>}.
6. Select the desired setting, then press {>}.
7. Press {ih}.
Setting pause length
Change the pause length of the cordless
handset, if necessary, depending on the
requirements of your service provider or PBX.
1. Press {j/OK}.
2. Select “Base Unit Setup”, then press
{>}.
3. Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page 73).
4. Select “Call Options”, then press {>}.
5. Select “Pause Length”, then press {>}.
6. Select the desired setting, then press {>}.
7. Press {ih}.
{ih}
{j/OK}
{>}
{C/T}
FC962HK-PFQX2283ZA-en.book Page 72 Thursday, September 15, 2005 4:20 PM
