Selecting the Lead
M3500B HeartStart XLT Defibrillator/Monitor 4-5
4
Selecting the Lead
Available monitoring leads are dependent upon your device configuration:
To select a lead to monitor, cycle through the choices by pressing until
the desired lead is displayed.
NOTE When V lead is selected, change to a different V lead by moving the electrode
to a new location rather than by pressing the softkey.
Figure 4-3 ECG Monitoring Display
If the desired lead is not connected or the electrodes are not making proper
contact with the patient, the message /HDGV2II is displayed in the System Mes-
sage Area and accompanied by a beep to alert you. A dashed line on the dis-
play indicates that there is no ECG signal.
Table 4-3 Lead Select Choices
Lead Select
Choices are:
If Configured for a:
Pads, Lead I, Lead II, Lead III 3-lead ECG cable
Pads, Lead I, Lead II, Lead III, aVR,
aVL, aVF, V lead.
5-lead ECG cable
/($'
6(/(&7
/($'
6(/(&7
PAUSE
HR ALARM
LEAD
SELECT
ANALYZE
Shocks: 3
00:00:49
Monitoring Rhythm
78
Lead II
