B – Command Line Interface
Reset Command
B-18 59042-00 A
Reset Command
Resets the switch and port configuration parameters.
Authority Admin
Syntax reset
config
factory
port [port_number]
snmp
switch (default)
system
zoning
Keywords config
Resets the configuration settings for the switch and its ports to the factory default
values. Refer to Table B-2 and Tabl e B-3 for switch and port configuration default
values.
factory
Resets switch, port, SNMP, and system configuration settings to the factory
default values. Refer to Tab le B-2 through Table B-5.
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning with
0.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table B- 4 for SNMP configuration default values.
switch
Reinitializes the switch. This command also closes the Telnet session.
system
Resets the system configuration settings to the factory default values. Refer to
Table B- 5 for system configuration default values.
zoning
Resets the zoning configuration settings to the factory default settings. This
keyword clears all zoning definitions on the switch.
