B – Command Line Interface
Set Config Command
B-26 59042-00 A
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Table B-7. Set Config Switch Parameters
Parameter Description
AdminState Switch administrative state: online, offline,
or diagnostics.
Broadcast Enable Enables or disables (default) forwarding if
broadcasting frames.
DefaultDomainID Default domain ID setting
DomainIDLock If set to True (default), prevents domain ID
from being changed.
SymbolicName Descriptive name
R_T_TOV Receiver Transmitter Timeout Value.
Specifies the number of milliseconds a
port is to wait to receive a response from
another port. The default is 100.
R_A_TOV Resource Allocation Timeout Value. The
number of milliseconds the switch waits to
allow two ports to allocate enough
resources to establish a link. The default is
10000.
E_D_TOV Error Detect Timeout Value. The number
of milliseconds a port is to wait for errors to
clear. The default is 2000 msec.
FS_TOV Fabric Stability Timeout Value. The default
is 5000 msec.
DS_TOV Distributed Services Timeout Value
(Management Server, Name Server). The
default is 5000 msec.
PrincipalPriority The priority used in the FC-SW-2 principal
switch selection algorithm. 1 is high, 255 is
low.
Description The name for the configuration. The
default is undefined.
