Chapter 2 Installation
Installing an Internal LTO-3 Tape Drive
10 LTO-3 Tape Drive User’s Guide
Terminator Power 2
By default, terminator power is disabled on the internal LTO-3 Tape
Drive. To enable terminator power, place a jumper across pins 11 and 12.
2 Open Shunted Open Open
3 Shunted Shunted Open Open
4 Open Open Shunted Open
5 Shunted Open Shunted Open
6 (default) Open Shunted Shunted Open
8 Open Open Open Shunted
9 Shunted Open Open Shunted
10 Open Shunted Open Shunted
11 Shunted Shunted Open Shunted
12 Open Open Shunted Shunted
13 Shunted Open Shunted Shunted
14 Open Shunted Shunted Shunted
15 Shunted Shunted Shunted Shunted
Note: The internal LTO-3 Tape Drive does not provide SCSI
termination. Thus, a terminator must be installed on the drive
if it is the last device in a SCSI chain.
SCSI ID
Jumpers
1–2 3–4 5–6 7–8
