32
• If the parameter display disappears, start from the
step again.
At the desired parameter, adjust it as desired.
2
Repeat the above steps and to adjust
other parameters.
3
ENGLISH
• When selecting the Dolby Virtual Speaker Reference mode(“DOLBY (D) VS REF”) or the Dolby Virtual Speaker
Wide mode(“DOLBY (D) VS WIDE”), you can select the desired one of different speaker layouts for actual
speakers to be used.
• Press the PARAMETER button to select the desired speaker layout.
• Each time this button is pressed, the speaker layout mode changes
depending on the selected Dolby Virtual Speaker mode as follows:
* In case of Dolby Virtual Speaker Reference mode,
2 SPK : When using 2 front speakers only
3 SPK : When using 2 front and center speakers
* In case of Dolby Virtual Speaker Wide mode,
2 SPK : When using 2 front speakers only
3 SPK : When using 2 front and center speakers
4 SPK : When using 2 front and 2 surround speakers
5 SPK : When using 2 front, center and 2 surround speakers
Note : When the speakers are set to “None”, the corresponding speaker layout modes cannot be selected.
Selecting the desired speaker layout for Dolby Virtual Speaker mode
Enter the test tone mode.
1
• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the EXTERNAL IN is selected as an input source, the SPEAKER button is set to off or it is in the
stereo mode, the test tone function does not work.
Adjusting each channel level with test tone
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL C FR SR SB SL
Front Left Center Front Right Surround Surround Surround
Right Back Left
SW
Subwoofer
• When the speaker setting is “N”, the test tone of the
corresponding channel is not available.
