page 89MARK-V FT-1000MP Operating Manual
CAT System Computer Control
STATUS UPDATE DATA ORGANIZATION
1863-Byte Status Updata Data (sent L-to-R)
6-Byte Status Flags Record Table
Status Memory Operating VFO-A VFO-B Memory
Flags Channel No. Data Data Data Data
6 byte 1 byte 16 byte 16 byte 16 byte 16 bytes (
x 113 memories = 1808 bytes total
)
(
A
) (
B
) (
C
) (
D
) (
E
) (
F
)
Bit
STATUS FLAG BYTE #1 CONTENTS
Offset
0 Split Frequency Operation
1 Dual Receive Operation
2 Antenna Tuning In Progress
3
CAT
System Activated
4 SUB VFO-B In-Use
(
Rx/Tx LED on
)
5 Keypad Entry In Progress
6 Main Receiver Muted
7 PTT Keyed
(
Tx Active
)
Bit
STATUS FLAG BYTE #2 CONTENTS
Offset
0 5-sec. MEM CHK Timer Active
1 Memory Checking In Progress
2 Dual VFO Tracking Active
3 Quick Memory Bank Selected
4 Memory Tuning Active
5 VFO Operation
6 Memory Operation
7 General Coverage Reception
Bit
STATUS FLAG BYTE #3 CONTENTS
Offset
0 FAST Tuning Active
1 Antenna Tuner
(
ATU
)
In-Line
2 SUB VFO-B Locked
3 MAIN VFO-A Locked
4 Squelch Closed
5 Scan Direction
(
Up/Down
)
6 Scan Paused
7 Auto Memory Write Scanning Active
Bit
STATUS FLAG BYTE #4 CONTENTS
Offset
0 2nd IF 455 kHz Filter Selection Active
1 1st IF 8.2 MHz Filter Selection Active
2 N/A
3 N/A
4 PTT Keyed via
CAT
Command
5 General Coverage TX Inhibit
6 Key Release Timer Active
7 Tx Inhibit
Bit
STATUS FLAG BYTE #5 CONTENTS
Offset
0 RTTY TX Idle
1 N/A
2 N/A
3 Grouped Memory MOde Active
4 ANT B Selected
5 RX ANT Selected
6 PMS Tuning Active
7 AM Synchronous Mode Active
Bit
STATUS FLAG BYTE #6 CONTENTS
Offset
0 Sub Receiver Audio Muted
1 Main Receiver Audio Muted
2 Dual VFO Tracking
3 N/A
4 N/A
5 VFO Channel Stepping
6 Tuner Wait
(
while tuning
)
7 AM Synchronous Mode Active
