24
SE5
English
4. SET UP
■ MOUNTING THE HANDLE
• Tighten the grip firmly. If the
grip becomes loose, it might
move while you are working,
causing danger.
• Do not loosen or twist the grip
while you are working.
• Always stop the engine and
make sure the blade has
stopped before adjusting the
position of the loop handle.
1. Remove the grip of the loop
handle, washer and mounting bolt
associated with this product, and
remove the stopper.
2. Push the loop handle onto the
main pipe as shown in Fig. 5.
Be careful not to mount the loop
handle in the wrong direction.
3. Push the stopper in the direction of
the arrow as shown in Fig. 5 and
insert the mounting bolt. Then,
position the hanger plate and
washer around the mounting bolt,
and turn the grip to tighten the
hanger plate and washer slightly.
4. Align the end of the loop handle
with the serial number label, and
tighten and fix the grip.
(1) Mounting bolt
(2) Serial number label
(3) Main pipe
(4) Main pipe
(5) Engine side
(6) Stopper
(7) Washer
(8) Grip
(9) Insert
(10) Loosen
(11) Loop handle
(12) Hanger plate
(13) Tighten
NOTE
주십시오.
오.
후에 실시하여 주십시오.
십시오.
파이프에 밀어 넣어 주십시오.
록 해 주십시오.
다음, 장착 볼트를 삽입합니다. 그
돌려서 가볍게 조여 주십시오.
십시오.
