English
4. SET UP
SE11
• When mounting the air cleaner
cover, fasten the knob after
inserting the nail of the air cleaner
body into the hole of the air
cleaner cover. At that time, make
sure that the choke lever is in the
“Open” position. If the choke lever
is in the “Closed” position, set it to
the “Open” position.
(1) Nail
(2) Hole
(3) Air cleaner cover
(4) Choke lever
(5) “Open” position
(6) “Closed” position
■ INSTALLING DEBRIS GUARD
Do not use this machine without
the debris guard.
Fit the top of the debris guard to the
gear case, install the debris guard
on the main pipe with the accessory
clamp, and tighten the debris guard
evenly with two Phillips screws
(M5xL25).
[Tightening torque]
2.6 to 4.9 N-m (27 to 50 kgf-cm)
(1) Clamp
(2) Phillips screw (M5xL25)
(3) Main pipe
(4) Safety-guard cover
(5) Fit this part to the gear case.
