ES-2108/ES-2108-G User’s Guide
160 Chapter 27 Introducing the Commands
27.9.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
<T1|T2>lacp
Enables LACP for a trunk
group.
interface <port-
list> timeout
<lacp-timeout>
Defines the port number and
LACP timeout period.
vlan <1-4094>
Enters the VLAN configuration
mode. See Section 27.9.5 on
page 162 for more information.
vlan-type <802.1q|port-based>
Specifies the VLAN type.
vlan1q gvrp
Enables GVRP.
ingress-check
Enables VLAN tag checking on
incoming traffic.
port-isolation
Enables port-isolation.
wrr
Sets the switch to use Weighted
Round Robin queuing (WRR).
<wt1 .. wt4>
Sets the WRR weight. A weight
value of one to eight is given to
each variable from
wt1 to wt4.
Table 58 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION
Table 59 interface port-channel Commands
COMMAND DESCRIPTION
interface
port-channel
<port-list>
Enables a port or a list of ports
for configuration.
bandwidth-limit
Enables bandwidth control on
the port(s).
egress <kbps>
Sets the maximum bandwidth
allowed for outgoing traffic on
the port(s).
ingress <kbps>
Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
bmstorm-limit
Enables broadcast storm
control on the port.
<Kbps>
Sets the limit of broadcast storm
packets in kilobit per second
(Kbps).
diffserv
Enables DiffServ on the port(s).
