A SERVICE OF

logo

ES-2108/ES-2108-G User’s Guide
Chapter 29 IEEE 802.1Q Tagged VLAN Commands 185
This command turns on GVRP in order to propagate VLAN information beyond the switch.
29.4.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the switch does not propagate VLAN information to
other switches.
29.4.6 Enable Ingress Checking
Syntax:
ingress-check
Enables the device to discard incoming frames for VLANs that are not included in a port
member set.
The following example activates ingress checking on the switch.
Figure 133 ingress-check Command Example
29.5 Port VLAN Commands
You must configure the switch port VLAN settings in config-interface mode.
29.5.1 Set Port VID
Syntax:
pvid <VID>
where
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
ras(config)# vlan1q ingress-check
<VID> =
Specifies the VLAN number between 1 and 4094