ES-3148 User’s Guide
242 Chapter 34 Introducing Commands
baudrate <1|2|3|4|5>
Changes the console port speed.
Choices are 1 (9600), 2 (19200),
3(38400), 4 (57600) and 5
(115200).
13
boot config <index>
Restarts the system with the
specified configuration file.
13
reload config <index>
Restarts the system and use the
specified configuration file.
13
write memory
Saves current configuration to the
configuration file the switch is
currently using.
13
<index>
Saves current configuration to the
specified configuration file on the
switch.
13
copy tftp flash <ip>
<remote-file>
Restores firmware via TFTP. 13
tftp config
<index> <ip>
<remote-file>
Restores configuration with the
specified filename from the
specified TFTP server.
13
running-config
tftp <ip>
<remote-file>
Backs up running configuration to
the specified TFTP server with the
specified file name.
13
running-config
interface port-
channel <port>
<port-list>
Clones (copies) the attributes from
the specified port to other ports.
13
running-config
interface port-
channel <port>
<port-list>
[bandwidth-
limit ....]
Copies the specified attributes
from one port to other ports.
13
cable-
diagnosti
cs
<port-list>
Performs a basic connectivity test
on the ports. Displays “Ok” if
connector is inserted in the port,
“Open” if no connector is inserted
in the port or “Unknown” if this test
cannot determine the status.
13
ping <ip|host-name>
Sends Ping request to an Ethernet
device.
13
[vlan <vlan-
id>][..]
Sends Ping request to an Ethernet
device in the specified VLAN(s).
13
help
Displays command help
information.
13
tracerout
e
<ip|host-name>
[in-band|out-of-
band|vlan <vlan-
id>][ttl <1-
255>] [wait <1-
60>] [queries
<1-10>]
Determines the path a packet
takes to a device.
13
Table 85 Command Summary: Enable Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
