ES-3148 User’s Guide
64 Chapter 5 Initial Setup Example
1 Click Advanced Application and VLAN in the navigation panel and click the Static
VLAN link.
2 In the Static VLAN screen, select
ACTIVE, enter a descriptive name
in the Name field and enter 2 in the
VLAN Group ID field for the
VLAN2 network.
Note: The VLAN Group ID field in
this screen and the VID field in
the IP Setup screen refer to
the same VLAN ID.
3 Since the VLAN2 network is connected to port 1 on the switch, select Fixed to configure
port 1 to be a permanent member of the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames
properly, clear the TX Tagging check box to set the switch to remove VLAN tags before
sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory
are lost when the ES-3148’s power is turned off.
5.1.2 Setting Port VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames
are forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames
received on that port get sent to VLAN 2.
