ES-3148 User’s Guide
256 Chapter 34 Introducing Commands
igmp-querier-
mode
<auto|fixed|edg
e>
Sets the IGMP querier mode of a
port.
Selects
auto to treat the IGMP
queries normally,
fixed to
always treat the port as a querier
port no matter there is a query or
edge to treat the port as a non-
querier port which drops any IGMP
queries received.
13
pvid <1-4094>
The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1 to
4094 for the specified interface.
13
ingress-check
Enables the device to discard
incoming frames for VLANs that
are not included in a port member
set.
13
gvrp
Enables this function to permit
VLAN groups beyond the local
switch.
13
frame-type
<all|tagged|unt
agged>
Choose to accept both tagged and
untagged incoming frames, just
tagged incoming frames or just
untagged incoming frames on a
port.
13
name <port-
name-string>
Sets a name for the port(s). Enter
a descriptive name (up to nine
printable ASCII characters).
13
vlan-trunking
Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
switch.
13
flow-control
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
13
bandwidth-limit
Enables ingress (pir), cir and
egress limits on the port(s).
13
cir
Enables the guaranteed bandwidth
limits for incoming traffic on the
port(s).
13
cir <Kbps>
Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir
Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir <Kbps>
Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
Table 87 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE
