ZyXEL Communications IES-1000 Manual

next previous

IES-1000 Hardware Installation Guide

Hardware Connections 4-1

Chapter 4

IES-1000

Connections

This chapter shows you how and where to make hardware connections.

Before you make your hardware connections, make sure that your IES-1000 is safely and securely positioned.

4.1 Front Panel Connections

All connections are made on the front panel of the IES-1000. The following figure shows the front panel

connections of the SAM1008. A more detailed discussion follows. Connections for the AAM1008 are the same

except for the DSL ports (see 4.4 for details).

Figure 4-1 SAM1008 Front Panel Connections Overview

4.2 Console Port

For the initial configuration, you need to use terminal emulator software on a computer and connect it to a

network module through the console port. Connect the mini-RJ-11 end of the console cable to the console port of

the network module. Connect the other end to a serial port of your computer. After the initial setup, you can

modify the configuration remotely through Telnet connections.