P314 Broadband Sharing Gateway with 4-Port Switch
10-4 System Maintenance and Information
Table 10-2 Call History Fields
Field Description
Phone Number The PPPoE service names are shown here.
Dir This shows whether the call was incoming or outgoing.
Rate This is the transfer rate of the call.
#call This is the number of calls made to or received from that telephone
number.
Max This is the length of time of the longest telephone call.
Min This is the length of time of the shortest telephone call.
Total This is the total length of time of all the telephone calls to/from that
telephone number.
10.3 Boot Commands
When you reboot your Prestige, you will be given a choice to go into debug mode by pressing a key at the
prompt shown in the following screen. In debug mode you have access to a series of boot module commands,
for example
ATUR
(for uploading firmware) and
ATLC
(for uploading the configuration file) already
discussed in Chapter 9.
Figure 10-6 Option to Enter Debug Mode
Enter
ATHE
to view all available Prestige boot module commands as shown in the next screen.
ATBAx
allows you to change the console port speed. The x denotes the number preceding the colon to give the
console port speed following the colon in the list of numbers that follows; e.g., ATBA3 will give a console
port speed of 9.6 Kbps.
ATSE
displays the seed that is used to generate a password to turn on the debug
flag in the firmware. The
ATSH
command shows product related information such as boot module version,
vendor name, product model, RAS code revision, etc.
ATGO
allows you to continue booting the system.
Most other commands aid in advanced troubleshooting and should only be used by qualified engineers.
Bootbase Version: V1.05 | 4/14/2000 13:58:03
RAM: Size = 4096 Kbytes
FLASH: Intel 8M
ZyNOS Version: V3.20(CA.0)b3 | 6/12/2000 18:00:34
Press any key to enter debug mode within 3 seconds.
.................................................
