A SERVICE OF

logo

Open as PDF
next previous
Chapter 6 Tutorials
XGS4700-48F User’s Guide
85
4 Enter 1 for both Start VID and End VID. Click Apply.
5 Then select Yes to enable PPPoE IA in VLAN 1 and also select Circuit-id and
Remote-id to allow the Switch to add these two strings to frames tagged with
VLAN 1 and pass to the PPPoE server. Click Apply.
The settings are completed now. If you miss some settings above, subscriber C
could not successfully receive an IP address assigned by the PPPoE Server. If this
happens, make sure you follow the steps exactly in this tutorial.
6.4 How to Use Error Disable and Recovery on
the Switch
This tutorial shows you how to shut down a port when:
• there is a loop occurred
or
• too many ARP requests (over 100 packets per second) received on a port