Menu Descriptions
61179641L4-5B 5-57
Dynamic IP Settings - for IP over ATM Menu
Dynamic IP Settings - for IP over ATM
Main Menu\System Management\Mode Selection and Current IP Settings\Dynamic IP Settings - for IP over ATM\
The Dynamic IP Settings - for IP over ATM menu (see Figure 5-34) is used to provision some of
the IP settings. When the Mode option is set to Dynamic, the Total Access 1248 system
automatically retrieves the IP address, Subnet mask, and Default Gateway from the remote
DHCP server. The remaining menu items can be provisioned manually.
Figure 5-34. Dynamic IP Settings - for IP over ATM Menu
The Dynamic IP Settings - for IP over ATM menu items are shown in Table 5-34.
Table 5-34. Dynamic IP Settings - for IP over ATM Menu Items
Option Description Function
N/A IP address This option cannot be changed. The IP address is
automatically retrieved from the DHCP server.
N/A Subnet mask This option cannot be changed. The Subnet mask is
automatically retrieved from the DHCP server.
3 VPI/VCI This option is used to configure the VPI/VCI setting. The
VPI and VCI are used to identify the next destination of a
cell as it passes through a series of ATM switches.
The VPI/VCI must also be provisioned at the upstream
ATM device.
4 PCR This option is used to configure the Peak Cell Rate
(PCR). The PCR is the maximum number of cells per
second that the ATM can transmit. The PCR default is
3000. Valid values range from 0 to 14488.
TID: TA1248 Total Access 1248
Unacknowledged Alarms: None
Dynamic IP Settings - for IP over ATM
IP address 0.0.0.0
Subnet mask 0.0.0.0
3. VPI/VCI 0/32
4. PCR 3000
Default Gateway Not Configured
6. TFTP IP address Not Configured
7. TL1 Port Number(set >1023) 13001
8. TL1 IP Transport type TCP
9. Reset IP Factory Defaults
MAC Address 00-a0-c8-12-6d-f9
Encapsulation is via rfc1483 SNAP
Selection :
'?' - System Help Screen
