Total Access 1248 Octal T1 IMA DSLAM Installation and Maintenance Practice
3-22 61179641L4-5B
10. From the T1 Provisioning menu, configure the Type, Framing, Line Code, and Line Build Out
setting to match the settings of the T1s provided. Press
N to access the next T1 to
configure and continue this process until all the T1s are properly configured.
11. From the T1 Provisioning menu, press
ESC to return to the T1 Main Menu.
12. From the T1 Main Menu, select T1 Status, and press
ENTER.
13. From the T1 Status menu, confirm that the T1s do not have active alarms.
NOTE
If the T1s have active alarms, this is an indication of a network feed
issue.
14. From the T1 Status menu, press
ESC until the Network Port menu displays.
15. From the Network Port menu, select
IMA and press ENTER.
16. From the IMA Main Menu, select
Provisioning, and press ENTER.
17. From the IMA Provisioning menu, select
IMA Facility, and press ENTER.
18. From the IMA Facility Provisioning for # 1 menu, select
Facility Operation Mode, and press
ENTER.
19. From the Operation Mode for Facility for # 1 menu, provision the facilities as appropriate.
For more information, refer to “Operation Mode for Facility Menu” on page 5-116.
The default settings assign the 8 facilities to the IMA Group.
20. From the Operation Mode for Facility for # 1 menu, press
ESC until the IMA Provisioning
menu displays.
21. From the IMA Provisioning menu, select
IMA Group, and press ENTER.
22. From the IMA Group Provisioning menu, select
Group Operation Mode, and press ENTER.
23. From the Group Operation Mode menu, select
In Service, and press ENTER.
24. Press
ESC until the Main menu displays.
25. From the Main menu, select
System Management, and press ENTER
26. From the System Management menu, select IP Address, and press ENTER.
27. From the Mode Selection and Current IP Settings menu, verify that the Mode is set to
Static.
28. From the Mode Selection and Current IP Settings menu, select
Configure IP, and press
ENTER.
29. From the Status IP Settings - for IP over ATM menu, configure the following fields:
• IP Address
•Subnet Mask
•VPI/VCI
•Default Gateway
