Scanning A Block of Channels (Block Scan)
You can scan through only specified block of channels. One block consists of 100 channel memory addresses. (‘34)
Hold down FUNC key and press 8 SCAN key.
(All channel scan starts.)
Enter the block number to be scanned using the numeric key. (Illust. 37)
To scan another block, enter the block number using the numeric key.
To end, press CLEAR PROGRAM key.
l When the block number is specified while in Memory Scan Memory, only specified channels within the
specified block are scanned through.
l A low pitched beep is emitted when no channel memory is programmed in the specified block and resumes all
channel scan.
Changing the Delay Time (Only Effective When Pause Type Scan is Chosen)
In a Pause Type Scan/Search, the scan or search operation is held for approximately 5 seconds. This time interval
can be changed with following procedure.
Hold down FUNC key and press 0 SET key.
Turn the selector to change the set menu display to „5 dLAY“. (Illust. 38-1)
Hold down FUNC key and turn the selector to change the display from „5“ to desired time.
(The halting time in second is displayed.) (Illust. 38-2)
To complete the procedure, press CLEAR PROGRAM key.
Using Dual Watch
The frequency in channel Pri (000) and one another frequency can be received alternatively. This is called Dual
Watch.
Set the unit to receive a channel or frequency of which you want to listen alternatively to the frequency in
PRIority channel (000).
Hold down FUNC key and press 0 SET key.
Turn the selector to change the set menu display to „OFF duAL“. (Illust. 39-1)
Hold down FUNC key and turn the selector by one click. (Illust. 39-2)
(The channel Memory address Pri is received every 5 seconds.)
To end, press CLEAR PROGRAM key.
Note:
l If the Channel Memory address Pri is empty and has no frequency programmed into, a low pitched beep is
emitted in Step 4 and returns remains dual watch ‘OFF’ state. Program the desired frequency in the Channel
Memory address Pri. (‘32)
Using A Dual Watch Function During Search/Scan
Dual Watch can be activated during search or scan operation.
Start Search (‘39) or Scan (‘43).
If you are in search mode, hold down FUNC key and press 3 SEARCH key or in scan mode, hold down FUNC
key and press 8 SCAN key.
(The channel memory address Pri is received every 5 seconds.) (Illust. 40)
To end, press CLEAR PROGRAM key.
