4. To complete this procedure, press CLEAR PROGRAM key.
Note:
l All the contents of channel memories are cleared during All Reset procedure even when this function is
activated.
l This function does not apply to protect Search Pass Channel Memories.
Erasing Channel Memories by Block at a Time
Channel Memory can be cleared by blocks. A block of channel memory is made up of 100 channel memory
addresses grouped consecutively. The relationship between the block number and the channel memory addresses
are shown below.
Block number Channel Memory address
0 001 - 099
1 100 - 199
2 200 - 299
3 300 - 399
Hold down FUNC key and press 0 SET key.
Turn the selector and change the Set menu to display „OFF bCLEAr“ (Illust. 23)
Enter the block number to be erased using the numeric keys.
To cancel the operation, press CLEAR PROGRAM key before Step 3. to cancel the Set Mode.
Exchanging the Contents of Channel memory (Channel Memory Swap)
The contents of channel memories can be swapped between two channel memory addresses.
Hold down FUNC key and press 0 SET key
Turn the selector and change the Set menu to display „SwAP“ (Illust. 24-1)
Select the first channel memory address by using the numeric keys. (The first channel Memory address is
displayed on the left side of SwAP.) (Illust. 24-2)
Enter the second channel memory address by using the numeric keys. (The second channel Memory address
is displayed on the right side of SwAP.
(A high pitched beep is emitted and the receiver will return to the FREQ Mode.)
Note:
This function cannot be used for Search Band Channel Memory and Search Pass Channel Memory.
Returning to the FREQ mode without changing the frequency in the Channel Memory Mode
When switched from the Channel Memory Mode to FREQ Mode, the receiver returns to the last frequency received
in FREQ Mode. Using this function, you can return to the FREQ Mode without changing the frequencies in Channel
Memory Mode .
Hold down FUNC key and press 0 SET key.
Turn the selector and change the Set menu to display „OFF m-bAC „ (Illust. 25)
Hold down FUNC key and turn the selector to change the display from „OFF“ to „on“.
To complete the procedure, press CLEAR PROGRAM key.
Select the Channel Memory address.
Press CLEAR PROGRAM key to return to FREQ mode. (A high pitched beep is emitted and returned to the
FREQ mode.)
This function cannot be used for Search Pass Channel Memory.
