How to Recall the Channel Memory [1]
The frequencies that have previously been programmed into channel memories can be recalled by using following
method.
Using the selector
Hold down FUNC key and press 7 FREQ/CH key to set to the channel memory mode.
(Illust. 18)
Turning the Selector in the clockwise direction to increase the channel memory address number. Turning
counterclockwise to decrease the channel memory address number.
Using the 5(Up) or ENT (Down) key
Hold down FUNC key and press 7 FREQ/CH key to set to the channel memory mode.
Hold down FUNC key and press 5 to increase the channel memory address. Hold down FUNC key and press
ENT to decrease the channel memory address.
Note:
Channel Memory addresses only appear when frequencies are programmed into.
How To Recall the Channel Memory [2]
A channel memory address can be recalled directly using the numeric keys.
1. Hold down FUNC key and press 7 FREQ/CH key to set to the channel memory mode.
(Illust. 20-1)
2. Enter desired 3-digit channel Memory address using the numeric keys.
(The channel Memory address is called when the third digit has been entered.)
(Illust. 20-2)
How To Erase The Frequencies Programmed into Channels
Stored channel memory can be erased in following procedure.
Set the unit to Channel Memory Mode by pressing the 7 FREQ/CH key while the FUNC key is pressed. „M“
should appear on the display.
Select the channel memory address to be erased by directly entering the channel memory number with
numeric keys or using rotary selector. (Illust. 21-1)
Hold down FUNC key and press CLEAR PROGRAM key. („CLr“ is displayed.)
(Illust. 21-2)
Hold down FUNC key and press CLEAR PROGRAM key once again.
( High pitched beep is emitted and the channel memory mode returned.)
Note:
l The contents of channel memory cannot be retrieved once they are cleared. If you wish to cancel the
operation, release FUNC key and simply press CLEAR PROGRAM key alone before proceeding to Step 4.
l When the last channel memory address has been cleared, the receiver returns to the FREQ Mode after Step 4.
How to Protect Frequencies Programmed in to Channel Memories (Channel Memory Protect)
If you wish to prevent channel memories from accidentally be overridden or erased, following procedure must be
taken.
1. Hold down FUNC key and press 0 SET key.
2. Turn the selector and change the Set menu to display „OFF Pro“. (Illust. 22-1)
3. Hold down FUNC key and turn the selector to change the display from „OFF“ to „on“.
(Illust. 22-2)
