DATALOGIC MEMOR™
1 2
2.2 RS232 CONNECTION
You can use a cable to directly connect the Datalogic Memor™ to a host
computer to transfer data through the RS232 interface.
C
B
Key:
A) Host Computer C) Datalogic Memor™
B) 94A051022 WIN-NET
(HRS ST40X-18S-CV)
The Single Cradle can be connected to the Host by any standard 9-pin serial
null-modem cable for RS232 communications.
Once the Host has been turned on, insert the Datalogic Memor™ mobile
computer into the cradle.
B
C
D
Key:
A) Host Computer C) Single Cradle
B) 94A051020 CAB-427
Null-Modem
D) *Power Supply (only necessary for
battery charging)
In this case the power supply is only necessary for battery charging. Insert the
power supply plug into the power jack on the base of the cradle and attach the
power supply to a power outlet.
NOTE
If using the Datalogic Memor™ Single Ethernet Cradle, be sure
that the switch is in the “USB” position.
During switch operation from USB position to Ethernet position
and vice versa the mobile computer must not be inserted in the
cradle.
6
