A SERVICE OF

logo

Open as PDF
next previous
System Management Commands 1325
User Guidelines
This command is executed on the Management Switch.
Example
The following example displays how to reconfigure switch number “1” to an
identifier of “2.”
console(config)#switch 1 renumber 2
telnet
Use the telnet command in Privileged EXEC mode to log into a host that
supports Telnet.
Syntax
telnet {
ip-address | hostname
} [
port
] [
keyword1......
]
•
ip-address
— Valid IP address of the destination host.
•
hostname
— Hostname of the destination host. (Range: 1–158 characters)
•
port
— A decimal TCP port number, or one of the keywords from the port
table in the usage guidelines (see "Port Table" on page 1326).
•
keyword
— One or more keywords from the keywords table in the user
guidelines (see "Keywords Table" on page 1326).
Default Configuration
port —
Telnet port (decimal 23) on the host.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
console#telnet 1.1.1.1?